The film faced plywood board is made of multiple board skins bonded together and pressed by high temperature heating. It is inevitable that there will be problems during the processing. If bubbling and degumming occurs, what is the reason?
The reasons for this phenomenon are mainly concentrated in the selection of veneer, the choice of glue solvent and the control of hot pressing time. In the processing technology of veneer, the moisture content of the veneer and insufficient drying and charging will cause bubble. If the gluing solvent is applied too much, or the optimal temperature and time of the gluing solvent are exceeded, it will cause the plywood to open. The control of the hot pressing time is directly related to the dryness of the veneer, and the production personnel must ensure the reasonable use of the hot press and the veneer products to determine the best hot pressing time.
ZMADTO Plywood Co.Ltdis focus on construction plywood & wood formwork product. Our factory was established in 1993 and covers an area of 240,000 square meters with an average daily output of more 30,000 pcs plywood. Besides, the factory has more than 200 advanced equipment. After years of continuous development, it has become a leading company in the international wood formwork industry and exported to more than 20 countries around the world.
